Initial clicks, but engine does not turn – Tech in Trunk?

If the car starter clicks and the engine does not rotate, this can be caused by several factors. The most common reason for starting a car is the low battery. Most people assume that the starter is bad if it just clicks, but the low voltage causes the starter to make that sound.

The battery is the heart of the novice and the electrical system. If the battery is discharged or the cell is weak, the start can only be triggered. Many times the battery could be lowered because a door was slightly open and the dome remained. Other times, a vanity or phone charger may remain. In the time of my master automobile technician I had a reliable fellow in the trunk to make sure the trunk was asleep when the trunk was closed.

To charge the battery, a good charge is required. When the battery is fully charged, the tester indicates that it needs to be charged before testing. The first step in checking the starter and the electrical system is to ensure that the battery is in good condition. Most parts store the batteries for free. After finding that the battery is good, the rest of the system can be checked. Loose or corroded connections may also cause clicks and the car will not start.


The starter solenoid valve is located on its inner fender funnel for many Ford vehicles, and for most other vehicles, the starter solenoid can be mounted on the starter. The audible click of the solenoid valve is often heard. But low voltage can lead to a drained battery, a bad battery, or bad connections. In most cases, if the vehicle can be started, the starter is in order. This may also indicate that joining the starter is good.


After the vehicle is running, the output of the generator can be checked. If the generator does not charge the battery, it will condense when the car is started and driving. When the generator is checked, the voltage and power output are measurable. The diode pattern must also be checked to ensure that the generator does not empty the battery when the engine is switched off. In the past, drivers can interrupt the battery while the vehicle is running to control the generator when the car is running on the generator. This may be detrimental to computer vehicles. If the battery drains while a computer vehicle runs at the output of the generator, it can increase the surge to snoop the computer.


When purchasing a replacement battery, check the cold start amplifier for the vehicle. It is best to purchase the battery with the minimum required minimum cold start power. When purchasing this item, you must consider whether maintenance is required or not. If the battery is difficult to reach or has a cover plate, the maintenance-free battery is beneficial. For example, in some Chrysler Sebrings and Chevrolet Corvette, the battery is located behind an inner mudguard and a Chevrolet SSR. the battery is placed under the bed where the spare tire usually goes. If you install the battery, make sure that the side is positive and negative if you have sold the wrong battery.


Terminals must be free from injury and should be well-sealed. Sometimes, especially in imported vehicles, battery terminals will be very thin and hairline cracks may cause poor connections. Do not touch the battery jamming. The battery charger may cause damage that may cause leakage if battery acid is emptied and can cause rapid corrosion. If the battery's end bolts do not protrude, it is recommended to replace the connectors. If the connections are tight, you will not be able to twist them.

Source by Dennis Bandy

Leave a Reply

Your email address will not be published. Required fields are marked *