How to convert a black color iPhone 4 to a white model

Are you scared of the fact that you bought the black iPhone 4 because Apple had problems with the production of a white model? Waiting for the solution to keep the current device and switch between the two? If this topic is for you, look no further, the following article describes the step-by-step approach on how to convert the black iPhone 4 protein.

The first step in this transformation is to understand what needs to be changed. The components that need to be replaced by the glass screen / lcd unit and the back cover. The underside of the device is the same for both models.

The second step of the fix is ​​to get the right tools for the job. The tools you need are a Phillips screwdriver, an opening device, a flathead screwdriver, and most importantly, lots of patience.

The step-by-step disassembly instructions are as follows: Remove the back cover by removing the two screws on the bottom of the phone and pushing it up. Follow the instructions below:
First, remove the SIM card holder. Second, remove the battery with the battery's earmold up. Then remove the siren by unscrewing the two screws and holding it in place. Then remove the five screws at the top of the phone and remove the ribbon cover. Then lift up the 5 sheets attached to the system board. Then unscrew the large screw near the tabs on the top of the system board. Then remove the watermark in the center of the phone and remove the screw. Then remove the two screws on the metal plate in the center of the phone. Then remove the metal plate and remove the cable connected to the system board. Then remove the two screws at the bottom of the phone. Then remove the camera tab and pull the camera up. Then remove the small connector at the bottom of the iPhone. Then remove the system board slightly upwards. Then remove the 10 screws on top of the screen. Then remove the case from the drawer from the case. Please take the previous steps at your own risk. The components of the phones are very fragile.

After removing the black cover and the screen, the white parts must be prepared. The screen / digitizer / lcd unit must use the grid grill from the old screen to the new one. Also make sure that the back cover is fitted with the rail / plastic frame. After making sure that the above steps are completed, replace the iPhone with the above white parts.

This is a very difficult process, but frustrates many iPhone users who just can not wait to release the white model.

There are many other conversion colors available through the remanufactured repair shops; Be careful, however, that you should not use a non-apple rating as it will immediately terminate the warranty.

Source by Jeremy Bates

Leave a Reply

Your email address will not be published. Required fields are marked *